WELDINGER A 202 W Dim. 1.6 x 500 mm for TIG soldering

Copper – silicon welding rod for TIG soldering

This product is available in other packaging units. You can also find offers here in the store.

Standards

EN 14640 S Cu 6560 (CuSi3Mn1)
DIN 1733 SG – Cu Si 3
Material no. 2.1461
AWS SFA-5.7 ER Cu Si – A

Technical data WELDINGER TIG solder CUSI3 1.6 mm A 202 W

Scope of delivery WELDINGER TIG solder CUSI3 1.6 mm A 202 W

10 x WELDINGER rods A 202 W Dim. 1.6 x 500 mm for TIG soldering

Application and properties

Arc brazing of galvanized, aluminized and uncoated steel sheets. Vehicle body construction, air conditioning, ventilation and container construction. The corrosion protection of galvanized surfaces is largely retained in the joining area. Distortion is kept to a minimum when soldering sheet metal. The lower hardness of the solder compared to the iron-based weld metal makes it relatively easy to work the seams in the visible area.

What is TIG soldering?

In manual TIG soldering, rod-shaped solder (copper alloy) is usually fed into the TIG arc in a similar way to autogenous brazing („flame soldering“) and melted in the arc. Copper-based materials such as FONTARGEN A 202 W have a significantly lower melting range than steel materials. Work is mainly carried out with a continuous arc. The tray position and drop position should be preferred to other soldering positions. There are no special requirements for the soldering equipment for TIG soldering. All commercially available TIG direct current sources and TIG torches are suitable for soldering. However, the current sources should be finely adjustable in the lower current range. Amperages of 20-100 A are sufficient for most applications.

Suitable base materials

Galvanized or aluminized sheet metal
Thin steel sheets
Thin stainless steel sheets

Advantages of TIG or MIG brazing on galvanized parts compared to welding

Reduced to no spatter formation during MIG soldering
Reduced pore formation
No burn-through on thin sheets
Higher strength on Zn sheets compared to welding
Particularly good dynamic strength
Less heat input, less distortion
Reduced to no zinc erosion
Higher corrosion resistance
Stainless joint seam
Greater gap bridging capability
Welding and soldering processes

TIG welding of copper alloys
TIG soldering
Type of current: Direct current (-pole)

Protective gases (DIN EN 439)
I 1 (welding argon) for TIG soldering
I 3 (argon/helium mixtures) can also be used instead of sulphur argon when welding copper.